next up previous contents
Next: Input and Output Files Up: Getting Started Previous: What is needed   Contents

Subsections


NAMD configuration file

Besides these input and output files, NAMD also uses a file referred to as the configuration file. This file specifies what dynamics options and values that NAMD should use, such as the number of timesteps to perform, initial temperature, etc. The options and values in this file control how the system will be simulated.

A NAMD configuration file contains a set of options and values. The options and values specified determine the exact behavior of NAMD, what features are active or inactive, how long the simulation should continue, etc. Section 2.2.1 describes how options are specified within a NAMD configuration file. Section 2.2.3 lists the parameters which are required to run a basic simulation. Section 7 describes the relation between specific NAMD and X-PLOR dynamics options. Several sample NAMD configuration files are shown in section 8.


Configuration parameter syntax

Each line in the configuration files consists of a $keyword$ identifying the option being specified, and a $value$ which is a parameter to be used for this option. The keyword and value can be separated by only white space:
keyword            value
or the keyword and value can be separated by an equal sign and white space:
keyword      =     value
Blank lines in the configuration file are ignored. Comments are prefaced by a # and may appear on the end of a line with actual values:
keyword            value          #  This is a comment
or may be at the beginning of a line:
#  This entire line is a comment . . .
Some keywords require several lines of data. These are generally implemented to either allow the data to be read from a file:
keyword            filename
or to be included inline using Tcl-style braces:
keyword {
  lots of data
}

The specification of the keywords is case insensitive so that any combination of upper and lower case letters will have the same meaning. Hence, DCDfile and dcdfile are equivalent. The capitalization in the values, however, may be important. Some values indicate file names, in which capitalization is critical. Other values such as on or off are case insensitive.


Tcl scripting interface and features

When compiled with Tcl (all released binaries) the config file is parsed by Tcl in a fully backwards compatible manner with the added bonus that any Tcl command may also be used. This alone allows:

Additional features include:

Please note that while NAMD has traditionally allowed comments to be started by a # appearing anywhere on a line, Tcl only allows comments to appear where a new statement could begin. With Tcl config file parsing enabled (all shipped binaries) both NAMD and Tcl comments are allowed before the first "run" command. At this point only pure Tcl syntax is allowed. In addition, the ";#" idiom for Tcl comments will only work with Tcl enabled. NAMD has also traditionally allowed parameters to be specified as "param=value". This is supported, but only before the first "run" command. Some examples:

# this is my config file                            <- OK
reassignFreq 100 ; # how often to reset velocities  <- only w/ Tcl
reassignTemp 20 # temp to reset velocities to       <- OK before "run"
run 1000                                            <- now Tcl only
reassignTemp 40 ; # temp to reset velocities to     <- ";" is required

NAMD has also traditionally allowed parameters to be specified as "param=value" as well as "param value". This is supported, but only before the first "run" command. For an easy life, use "param value".


Required NAMD configuration parameters

The following parameters are required for every NAMD simulation:

These required parameters specify the most basic properties of the simulation. In addition, it is highly recommended that pairlistdist be specified with a value at least one greater than cutoff.


next up previous contents
Next: Input and Output Files Up: Getting Started Previous: What is needed   Contents
namd@ks.uiuc.edu