Network Working Group                                  Brian A. Anderson
Request for Comments: 927                                            BBN
                                                           December 1984

                TACACS User Identification Telnet Option

Status of this Memo

   This RFC suggests a proposed protocol for the ARPA-Internet
   community, and requests discussion and suggestions for improvements.
   Distribution of this memo is unlimited.

Introduction

   The following is the description of a TELNET option designed to
   facilitate double login avoidance.  It is intended primarily for TAC
   connections to target hosts on behalf of TAC users, but it can be
   used between any two consenting hosts.  For example, all hosts at one
   site (e.g., BBN) can use this option to avoid double login when
   TELNETing to one another.

1. Command name and code

   TUID     26

2. Command Meanings

   IAC WILL TUID

      The sender (the TELNET user) proposes to authenticate the user and
      send the identifing UUID; or, the sender (the TELNET user) agrees
      to authenticate the user on whose behalf the connection is
      initiated.

   IAC WON'T TUID

      The sender (the TELNET user) refuses to authenticate the user on
      whose behalf the connection is initiated.

   IAC DO TUID

      The sender (the TELNET server) proposes that the recipient (the
      TELNET user) authenticate the user and send the identifing UUID;
      or, the sender (the TELNET server) agrees to accept the
      recipient's (the TELNET user's) authentication of the user
      identified by his UUID.

RFC 927                                                    December 1984
TUID Telnet Option

   IAC DON'T TUID

      The sender (the TELNET server) refuses to accept the recipient's
      (the TELNET user) authentication of the user.

   IAC SB TUID <uuid> IAC SE

      The sender (the TELNET user) sends the UUID <uuid> of the user on
      whose behalf the connection is established to the host to which he
      is connected.  The <uuid> is a 32 bit binary number.

3. Default

   WON'T TUID

      A TELNET user host (the initiator of a TELNET connection) not
      implementing or using the TUID option will reply WON'T TUID to a
      DO TUID.

   DON'T TUID

      A TELNET server host (the recipient of a TELNET connection) not
      implementing or using the TUID option reply DON'T TUID to a WILL
      TUID.

4. Motivation for the Option

   Under TACACS (the TAC Access Control System) a user must be
   authenticated (give a correct name/password pair) to a TAC before he
   can connect to a host via the TAC.  To avoid a second authentication
   by the target host, the TAC can pass along the user's proven identity
   (his UUID) to the that host.  Hosts may accept the TAC's
   authentication of the user or not, at their option.

   The same option can be used between any pair of cooperating hosts for
   the purpose of double login avoidance.

5. Description for the Option

   At the time that a host establishes a TELNET connection for a user to
   another host, if the latter supports the TUID option and wants to
   receive the user's UUID, it sends an IAC DO TUID to the the user's
   host.  If the user's host supports the TUID option and wants to
   authenticate the user by sending the user's UUID, it responds IAC
   WILL TUID; otherwise it responds with IAC WON'T TUID.  If both the
   user and server TELNETs agree, the user TELNET will then send the
   UUID to the server TELNET by sub-negotiation.

RFC 927                                                    December 1984
TUID Telnet Option

6. Examples

   There are two possible negotiations that result in the double login
   avoidance authentication of a user.  Both the server and the user
   TELNET support the TUID option.

      S = Server, U = User

      Case 1:

         S-> IAC DO TUID
         U-> IAC WILL TUID
         U-> IAC SB TUID <32-bit UUID> IAC SE

      Case 2:

         U-> IAC WILL TUID
         S-> IAC DO TUID
         U-> IAC SB TUID <32-bit UUID> IAC SE

   There are also two possible negoitiations that do not result in the
   authentication of a user.  In the first example the server supports
   TUID and the user TELNET doesn't.  In the second example the user
   TELNET supports TUID but the server TELNET doesn't.

      S = Server, U = User

      Case 3:

         S-> IAC DO TUID
         U-> IAC WONT TUID

      Case 4:

         U-> IAC WILL TUID
         S-> IAC DONT TUID

   The TUID is transmitted with the subnegotiation command.  For
   example, if the UUID had the value 1 the following string of octets
   would be transmitted:

      IAC SB TUID 0 0 0 1 IAC SE

   If the UUID had the value 255 the following string of octets would be
   transmitted:

      IAC SB TUID 0 0 0 IAC IAC IAC SE

RFC 927                                                    December 1984
TUID Telnet Option

   If the UUID had the value of all ones the following string of octets
   would be transmitted:

      IAC SB TUID IAC IAC IAC IAC IAC IAC IAC IAC IAC SE