|
|
|
|
| Author |
|
|
Registered
Join Date: May 2002
Posts: 70
|
3.2 fuel rail fittings
1. Does anyone know the correct fitting to convert 3.2 fuel rails to AN fittings.
Based on my research, I think its the following: female 16 x 1.5mm Metric Convex Seat to 6AN Male. ? 2. Would they also work for the fuel line in the back between the regulator and dampner? 3.Anyone know the fitting I need to connect to the fuel filter, from metric to AN? 4. Do they fit without hitting the manifolds? I'll have to use both the metric fitting and use the AN fitting for the hose so I hope I have enough room. Thanks for any advice. Last edited by JHP; 04-06-2020 at 12:32 AM.. |
||
04-05-2020, 11:00 PM
|
|
|
Registered
Join Date: Jul 2000
Location: So. Calif.
Posts: 19,910
|
AN is typically SAE threads and will need an adapter to transition. Tight fit around 3.2 intake fuel and hose paths.
Contact Len (boxstergt) for a possible solution. S |
||
|
04-06-2020, 11:01 AM
|
|
|
Registered
Join Date: Feb 2009
Location: Knoxville, TN
Posts: 1,349
|
This place has everything you need. https://www.batinc.net/plumbing
|
||
|
04-06-2020, 04:30 PM
|
|
|
Registered
Join Date: Feb 2009
Location: Knoxville, TN
Posts: 1,349
|
This thread has all of the goodies you need
Wanted: Braided Carrera Fuel Line |
||
|
04-06-2020, 04:34 PM
|
|
|
Registered
Join Date: May 2004
Location: New Hampshire
Posts: 6,023
|
 JHP- I have my line of "Direct Connect" AN fittings that crimp to Metric Hose directly, without adapters. They allow fitment in tight places such as the Fuel Rails.   For info please email me. Len.Cummings @ verizon.net
|
||
|
04-07-2020, 07:39 AM
|
|
