DIY Dog Bed

If you have a dog you know how hard is to keep his bed clean at all times. My dog Floo has several pillows and I wash these almost every week! I have quite small washing machine and sometimes it's difficult to get rid of all the dirt as pillows are quite huge :-/ That's why I decided to sew a pillow case that I can easily remove and wash properly anytime it's necessary. 

What you need:
- 2 rectangles of durable fabric such as denim, corduroy, or heavy cotton
- 4 side rectangles (as on picture)
- fiberfill stuffing or previously used dog pillow (in my case),
- zip 16-18 inches long
- sewing machine & polyester or cotton thread
- scissors, chalk and ruler

Instructions:
1. Measure pillow first. My pillow is 65 cm long, 60 cm wide and 10 cm high. 
2. Cut two large rectangles ( length x width ) and 4 side rectangles ( 2 rectangles = length x height and 2 rectangles = width x height ) from desired fabric as per below picture:

3. Pin and sew all side rectangles together to create large "square". If you want to make the project easier use only 1 long stripe for sides instead of cutting 4 smaller rectangles. I personally think the pillow looks better when sides are created from 4 individually cut rectangles.

4. Pin and sew this "square" with one large rectangle together. Make sure right sides of fabric face each other. For added durability, create a second row of stitches right inside the first row of stitches.

When you turn right side out you should have now clean edges like this on each side:

5. Pin and sew sides of "square" to the other rectangle. Leave 1 shorter side open. We will add a zipper to this side shortly.

6. If zip is shorter than width of the pillow, sew few cm/inches from each side.

7. Sew the last piece of "square" and zipper together using a zip footer. Make sure you leave a zip half open so you can turn right side out through it when you're finished! 

8. Turn your case right-side-out and fill it with a pillow. And that's it! You have just created easy-to-remove, machine washable pet bed!

If you have any question about the project or any recommendation and useful links please leave a comment! Thanks!!