Showing posts with label DIY Craft table tutorial. Show all posts
Showing posts with label DIY Craft table tutorial. Show all posts

Monday, September 9, 2013

DIY Craft Table Tutorial



Pinned over 20,000 times. 
Thank you for reading my 
DIY 
CRAFT TABLE TUTORIAL



This is the photo on my DIY Pinterest Board. 




We interrupt your regularly scheduled tutorial to bring you this PSA. Think safety first!!  Please don't forget to wear safety goggles, earplugs, and a mask:)) This is me using the power sander to redo our stairway.  Now onto the DIY Craft Table Tutorial!!




My craft table was made using the following tools: The size depends on the size of your room, and allowing for a 3-4 foot clearance on all sides. My table is 6 feet x 4 feet.

*3/4 inch thick Birch Plywood (cut to size at your home improvement store)
*carpenter's wood glue ( I used Gorilla Wood Glue)
*finishing nails
*stainable wood putty
*drill(bit size= smaller than your finishing nails)
*red oak trim molding(enough to fit around your table, cut to size at store) mine came to 20ft.
*stain of choice( I used Minwax Stain and Sealer in Bombay Mahogany)
*power sander
*3/4 inch square dowel
*safety gear( Earplugs, mask, goggles)
*work gloves
*countersink tool
*stain applicators of choice(read the back of your stain can to see if it recommends a brush or staining cloth)




Apply wood glue along edge of your tabletop and place trim , hold in place while you drill a pilot hole through the trim and tabletop. Countersink your finishing nails. Repeat for all sides. Apply wood putty over the nails and sand after dry.




Countersink tool.




My red oak molding came in 20 foot sections, so in order to use one piece, I just had the home improvement store make straight cuts the same length as the sides of my tabletop. Then to fill in the gap at the corners, I used a 3/4 inch square dowel and attached it with wood glue and finishing nails. I used the power sander to create the detail to somewhat match the molding trim piece.




Apply stain according to the directions on your can,  and allow to dry appropriate time before placing on your bases. Enjoy your handiwork!! Thank you for visiting today and don't forget to subscribe and comment to make my day:)