|
CATIA Viewset (catia-01)
The catia-01 viewset was created from traces of the graphics
workload generated by the CATIA™ V5R12 application from Dassault
Systemes.
Three models are measured using various modes in CATIA. Phil
Harris of LionHeart Solutions, developer of CATBench2003, supplied
SPEC/GPC with the models used to measure the CATIA application.
The models are courtesy of CATBench2003 and CATIA Community.
The car model contains more than two million points. SPECviewperf
replicates the geometry represented by the smaller engine block
and submarine models to increase complexity and decrease frame
rates. After replication, these models contain 1.2 million vertices
(engine block) and 1.8 million vertices (submarine).
State changes as made by the application are included throughout
the rendering of the model, including matrix, material, light
and line-stipple changes. All state changes are derived from a
trace of the running application. The state changes put considerably
more stress on graphics subsystems than the simple geometry dumps
found in older SPECviewperf viewsets.
Mirroring the application, draw arrays are used for some tests
and immediate mode used for others. See notes on specific tests
for more information.
|
Test
|
Weight
|
Description
|
|
1
|
9
|
Engine, SHD, immediate mode
|
|
2
|
9
|
Engine, SHD with edges, vertex arrays
|
|
3
|
9
|
Engine, SHD with hidden ddges, immediate
mode
|
|
4
|
9
|
Car, SHD, immediate mode
|
|
5
|
10
|
Car, NHR, immediate mode
|
|
6
|
9
|
Submarine, SHD, immediate mode
|
|
7
|
9
|
Submarine, NHR, immediate mode
|
|
8
|
9
|
Submarine, NHR, anti-aliased lines, immediate
mode
|
|
9
|
9
|
Submarine, SHD with edges, immediate mode
|
|
10
|
9
|
Submarine, HRD, vertex arrays
|
|
11
|
9
|
Submarine, SHD with hidden edges, immediate
mode
|
|
