tc-flower
Flower filter in tc(8) Linux Flower filter in tc(8)
NAME
flower - flow based traffic control filter
SYNOPSIS
tc filter ... flower [ MATCH_LIST ] [ action ACTION_SPEC ] [ classid
CLASSID ] [ hw_tc TCID ]
MATCH_LIST := [ MATCH_LIST ] MATCH
MATCH := { indev ifname | verbose | skip_sw | skip_hw | { dst_mac |
src_mac } MASKED_LLADDR | vlan_id VID | vlan_prio PRIORITY |
vlan_ethtype { ipv4 | ipv6 | ETH_TYPE } | cvlan_id VID |
cvlan_prio PRIORITY | cvlan_ethtype { ipv4 | ipv6 | ETH_TYPE }
| mpls_label LABEL | mpls_tc TC | mpls_bos BOS | mpls_ttl TTL |
ip_proto { tcp | udp | sctp | icmp | icmpv6 | IP_PROTO } |
ip_tos MASKED_IP_TOS | ip_ttl MASKED_IP_TTL | { dst_ip | src_ip
} PREFIX | { dst_port | src_port } { MASKED_NUMBER |
min_port_number-max_port_number } | tcp_flags MASKED_TCP_FLAGS
| type MASKED_TYPE | code MASKED_CODE | { arp_tip | arp_sip }
IPV4_PREFIX | arp_op { request | reply | OP } | { arp_tha |
arp_sha } MASKED_LLADDR | enc_key_id KEY-ID | { enc_dst_ip |
enc_src_ip } { ipv4_address | ipv6_address } | enc_dst_port
port_number | enc_tos TOS | enc_ttl TTL | geneve_opts OPTIONS |
ip_flags IP_FLAGS
DESCRIPTION
The flower filter matches flows to the set of keys specified and as-
signs an arbitrarily chosen class ID to packets belonging to them. Ad-
ditionally (or alternatively) an action from the generic action frame-
work may be called.
OPTIONS
action ACTION_SPEC
Apply an action from the generic actions framework on matching
packets.
classid CLASSID
Specify a class to pass matching packets on to. CLASSID is in
the form X:Y, while X and Y are interpreted as numbers in hexa-
decimal format.
hw_tc TCID
Specify a hardware traffic class to pass matching packets on to.
TCID is in the range 0 through 15.
indev ifname
Match on incoming interface name. Obviously this makes sense
only for forwarded flows. ifname is the name of an interface
which must exist at the time of tc invocation.
verbose
Enable verbose logging, including offloading errors when not us-
ing skip_sw flag.
skip_sw
Do not process filter by software. If hardware has no offload
support for this filter, or TC offload is not enabled for the
interface, operation will fail.
skip_hw
Do not process filter by hardware.
dst_mac MASKED_LLADDR
src_mac MASKED_LLADDR
Match on source or destination MAC address. A mask may be op-
tionally provided to limit the bits of the address which are
matched. A mask is provided by following the address with a
slash and then the mask. It may be provided in LLADDR format, in
which case it is a bitwise mask, or as a number of high bits to
match. If the mask is missing then a match on all bits is as-
sumed.
vlan_id VID
Match on vlan tag id. VID is an unsigned 12bit value in decimal
format.
vlan_prio PRIORITY
Match on vlan tag priority. PRIORITY is an unsigned 3bit value
in decimal format.
vlan_ethtype VLAN_ETH_TYPE
Match on layer three protocol. VLAN_ETH_TYPE may be either
ipv4, ipv6 or an unsigned 16bit value in hexadecimal format. To
match on QinQ packet, it must be 802.1Q or 802.1AD.
cvlan_id VID
Match on QinQ inner vlan tag id. VID is an unsigned 12bit value
in decimal format.
cvlan_prio PRIORITY
Match on QinQ inner vlan tag priority. PRIORITY is an unsigned
3bit value in decimal format.
cvlan_ethtype VLAN_ETH_TYPE
Match on QinQ layer three protocol. VLAN_ETH_TYPE may be either
ipv4, ipv6 or an unsigned 16bit value in hexadecimal format.
mpls_label LABEL
Match the label id in the outermost MPLS label stack entry. LA-
BEL is an unsigned 20 bit value in decimal format.
mpls_tc TC
Match on the MPLS TC field, which is typically used for packet
priority, in the outermost MPLS label stack entry. TC is an un-
signed 3 bit value in decimal format.
mpls_bos BOS
Match on the MPLS Bottom Of Stack field in the outermost MPLS
label stack entry. BOS is a 1 bit value in decimal format.
mpls_ttl TTL
Match on the MPLS Time To Live field in the outermost MPLS label
stack entry. TTL is an unsigned 8 bit value in decimal format.
ip_proto IP_PROTO
Match on layer four protocol. IP_PROTO may be tcp, udp, sctp,
icmp, icmpv6 or an unsigned 8bit value in hexadecimal format.
ip_tos MASKED_IP_TOS
Match on ipv4 TOS or ipv6 traffic-class - eight bits in hexadec-
imal format. A mask may be optionally provided to limit the
bits which are matched. A mask is provided by following the
value with a slash and then the mask. If the mask is missing
then a match on all bits is assumed.
ip_ttl MASKED_IP_TTL
Match on ipv4 TTL or ipv6 hop-limit - eight bits value in deci-
mal or hexadecimal format. A mask may be optionally provided to
limit the bits which are matched. Same logic is used for the
mask as with matching on ip_tos.
dst_ip PREFIX
src_ip PREFIX
Match on source or destination IP address. PREFIX must be a
valid IPv4 or IPv6 address, depending on the protocol option to
tc filter, optionally followed by a slash and the prefix length.
If the prefix is missing, tc assumes a full-length host match.
dst_port { MASKED_NUMBER | MIN_VALUE-MAX_VALUE }
src_port { MASKED_NUMBER | MIN_VALUE-MAX_VALUE }
Match on layer 4 protocol source or destination port number,
with an optional mask. Alternatively, the mininum and maximum
values can be specified to match on a range of layer 4 protocol
source or destination port numbers. Only available for ip_proto
values udp, tcp and sctp which have to be specified in before-
hand.
tcp_flags MASKED_TCP_FLAGS
Match on TCP flags represented as 12bit bitfield in in hexadeci-
mal format. A mask may be optionally provided to limit the bits
which are matched. A mask is provided by following the value
with a slash and then the mask. If the mask is missing then a
match on all bits is assumed.
type MASKED_TYPE
code MASKED_CODE
Match on ICMP type or code. A mask may be optionally provided to
limit the bits of the address which are matched. A mask is pro-
vided by following the address with a slash and then the mask.
The mask must be as a number which represents a bitwise mask If
the mask is missing then a match on all bits is assumed. Only
available for ip_proto values icmp and icmpv6 which have to be
specified in beforehand.
arp_tip IPV4_PREFIX
arp_sip IPV4_PREFIX
Match on ARP or RARP sender or target IP address. IPV4_PREFIX
must be a valid IPv4 address optionally followed by a slash and
the prefix length. If the prefix is missing, tc assumes a full-
length host match.
arp_op ARP_OP
Match on ARP or RARP operation. ARP_OP may be request, reply or
an integer value 0, 1 or 2. A mask may be optionally provided
to limit the bits of the operation which are matched. A mask is
provided by following the address with a slash and then the
mask. It may be provided as an unsigned 8 bit value representing
a bitwise mask. If the mask is missing then a match on all bits
is assumed.
arp_sha MASKED_LLADDR
arp_tha MASKED_LLADDR
Match on ARP or RARP sender or target MAC address. A mask may
be optionally provided to limit the bits of the address which
are matched. A mask is provided by following the address with a
slash and then the mask. It may be provided in LLADDR format, in
which case it is a bitwise mask, or as a number of high bits to
match. If the mask is missing then a match on all bits is as-
sumed.
enc_key_id NUMBER
enc_dst_ip PREFIX
enc_src_ip PREFIX
enc_dst_port NUMBER
enc_tos NUMBER
enc_ttl NUMBER
ct_state CT_STATE
ct_zone CT_MASKED_ZONE
ct_mark CT_MASKED_MARK
ct_label CT_MASKED_LABEL
Matches on connection tracking info
CT_STATE
Match the connection state, and can ne combination of
[{+|-}flag] flags, where flag can be one of
trk - Tracked connection.
new - New connection.
est - Established connection.
Example: +trk+est
CT_MASKED_ZONE
Match the connection zone, and can be masked.
CT_MASKED_MARK
32bit match on the connection mark, and can be masked.
CT_MASKED_LABEL
128bit match on the connection label, and can be masked.
geneve_opts OPTIONS
Match on IP tunnel metadata. Key id NUMBER is a 32 bit tunnel
key id (e.g. VNI for VXLAN tunnel). PREFIX must be a valid IPv4
or IPv6 address optionally followed by a slash and the prefix
length. If the prefix is missing, tc assumes a full-length host
match. Dst port NUMBER is a 16 bit UDP dst port. Tos NUMBER is
an 8 bit tos (dscp+ecn) value, ttl NUMBER is an 8 bit time-to-
live value. geneve_opts OPTIONS must be a valid list of comma-
separated geneve options where each option consists of a key op-
tionally followed by a slash and corresponding mask. If the
masks is missing, tc assumes a full-length match. The options
can be described in the form
CLASS:TYPE:DATA/CLASS_MASK:TYPE_MASK:DATA_MASK, where CLASS is
represented as a 16bit hexadecimal value, TYPE as an 8bit hexa-
decimal value and DATA as a variable length hexadecimal value.
ip_flags IP_FLAGS
IP_FLAGS may be either frag, nofrag, firstfrag or nofirstfrag
where frag and nofrag could be used to match on fragmented pack-
ets or not, respectively. firstfrag and nofirstfrag can be used
to further distinguish fragmented packet. firstfrag can be used
to indicate the first fragmented packet. nofirstfrag can be used
to indicates subsequent fragmented packets or non-fragmented
packets.
NOTES
As stated above where applicable, matches of a certain layer implicitly
depend on the matches of the next lower layer. Precisely, layer one and
two matches (indev, dst_mac and src_mac) have no dependency, MPLS and
layer three matches (mpls_label, mpls_tc, mpls_bos, mpls_ttl, ip_proto,
dst_ip, src_ip, arp_tip, arp_sip, arp_op, arp_tha, arp_sha and
ip_flags) depend on the protocol option of tc filter, layer four port
matches (dst_port and src_port) depend on ip_proto being set to tcp,
udp or sctp, and finally ICMP matches (code and type) depend on
ip_proto being set to icmp or icmpv6.
There can be only used one mask per one prio. If user needs to specify
different mask, he has to use different prio.
SEE ALSO
tc(8), tc-flow(8)
iproute2 22 Oct 2015 Flower filter in tc(8)
Man Pages Copyright Respective Owners. Site Copyright (C) 1994 - 2024
Hurricane Electric.
All Rights Reserved.