@6016.ADF - SMC3016/MC Ethernet Card 

SMC aquired Western Digital's network cards. So a WD8003 corresponds to a Elite 16 8003. 
 

 Legacy Driver location

WinNT 4.0 internal drivers exist for the SMC (WD) 8003E, 8003W, 8013EP, 8013WP 

The 3016TP is illustrated. The 3016MC has a BNC connector in place of the RJ45 jack and it lacks the COL and LNK LEDs.. 

JP1 and T1 Cable select 
JP2 Not installed 

Selecting Cable Connector
   Jumper J1 and the pulse transformer T1 are used to select the cable type used 

Board	Connector	Cable	J1	T1
3016TP/MC	RJ45	Twisted Pair	OUT	IN
	AUI	Thick	IN	OUT
3016MC	BNC	Thin	OUT	IN
	AUI	Thick	IN	OUT

LEDs

TX	Transmit
RX	Receive
COL	Collision (3016TP only)
LNK	Link integrity (3016TP only)

3016.exe   3016 Driver and utility disk 
3016MC-UGD.pdf   3016 Users Guide 

I/O Address Range
   Selects a 32 byte IO address range for the SMC3016/MC registers 
  <0300-031F>, 0340-035F, 0360-037F, 1980-199F, 2000-201F, 5680-569F, 5900-591F 

Boot PROM Address Range
   Selects an 8K byte memory address range for the Boot PROM. If there is no PROM installed, or you want to disable its operation, then select <PROM not used> 
 <PROM not used>, C200-C3FF, C400-C5FF, C600-C7FF, C800-C9FF, CA00-CBFF, CC00-CDFF, CE00-0CFF, D000-D1FF, D200-D3FF,  D400-D5FF, D600-D7FF, D800-D9FF, DA00-DBFF, DC00-DDFF, DE00-DFFF 

Interrupt Level Selection
    <IRQ3>, 9 (2), 10, 11, 15, 5, 4, 12 
These options are currently not supported 
   IRQ14, test only, IRQ7, IRQ6