ここから本文です
TWO:
Classification by type of system
1natural circulation external heating pipe type
2natural circulation calandria type
3forced circulation type
4falling-film type
5rising film type
6jacket type
7coil type
Classification by method of operation
1single effect evaporator system
2multiple effect evaporator system
3auto-vapor mechanical compression system
4auto-vapor ejector compression system
5multistage flash system

After taking into consideration of the physical and chemical property of solutions, the desired design conditions, and available utilities, we select the most suitable type of system by utilizing our years of experience and excellent results.
In addition, we can offer designs and manufacturing services that take into careful consideration compactness, energy-efficiency, and automatization.

THREE:That again was no use: he but got another smile and a friendly look of the sort he no longer wanted.When the time came there were partners for eight gallants, and the gallants numbered sixteen. They counted off by twos; the evens waited while the odds danced the half of each set, and then the odds waited and cooled, tried to cool, out on the veranda. But when a reel was called the whole twenty-four danced together, while the fiddler (from the contraband camp) improvised exultant words to his electrifying tunes.

While standard calandria type evaporation systems are widely used as the typical concentration evaporator by the various food and chemical industries, we have delivered many of those systems as finishing concentration evaporators especially for sugar solutions and starch syrups.

THREE:��Ah, I dare say he��ll find something he likes,�� said this dreadful old lady, observing with malicious{22} pleasure that Alice��s colour, as she would have phrased it, ��was mounting.��
  • Enables flexible operation with little influence from variations in load and raw solution concentrations because of an adequate amount of solution being held within the system. These systems are also suitable for batch type burning evaporators.
  • Concentrations can be controlled within product specifications by the cascade control using the concentrations of concentrated solution and the raw solution supply and also by the arithmetic control of raw solution concentrations, etc. (Result for sugar solutions: 75±0.2wt%)
  • High-viscosity solutions and solutions that may crystallize can also be utilized by installing a propeller in the evaporator as a forced circulation system.
THREE:��No, you didn��t mean that!�� said Keeling.{144}

This is a process example of a device that continuously and simultaneously concentrates two types of waste liquid with a single high-efficiency steam compressor.

THREE:Mrs Keeling��s powers of intuition could make nothing of this. Starting with the firm conviction that Mr Silverdale had proposed to her daughter, there seemed no place where it would fit in.
  • By evaporating the steam using a mechanical compressor and reusing it, almost no heating steam is alomost required except the time of start-up, so large energy savings can be expected.
  • By combining with a thin film falling heat exchanger that does not raise the boiling point due to the liquid depth, it is possible to utilize the temperature difference of the compressor at the maximum.
  • Since the residence time and heating time are short and the holding amount is small, starting and stopping can be performed in a short time.
  • It will prevent scale adhesion in the can that the evaporator is divided into two parts, and that the supply of the undiluted solution is alternately switched over a fixed period of time to perform heat concentration.