Sep 28, 2006 · That code erase procedure can only be done by a special Ford diagnostic tool, at the dealer. After they remove the codes, the PATS module will accept any keys with the simple procedure. It will accept the first key without any requirement. Then it will accept the 2nd PATS key only after the 1st is applied in the ignition.

OK TRY THIS PROCEDURE AND LET ME KNOW. Master Reset. 1-Disconnect Both Battery Cables ,Positive & Negative . 2- Touch Cables With Each Other For 60 Secs ( this will take any residual power in the Harness to Reset the Vehicle Modules ) 3- Wait 30 min. 4- Close all doors and trunk. 5- Reconnect Battery Positive First. 6- Use The Key in The Driver ...

NOTE:If the Body Control Module (BCM) was replaced on vehicles equipped with PATS, at least two keys must be programmed to the BCM. After completing step 3, do not disconnect the scan tool and follow the Erase All Keys and Program Two Keys procedure. From the scan tool, select "Parameter Reset" and follow the IDSon-screen instructions.

The Pats can be reset using a scanner or the procedure below. Master reset. 1-Disconnect Positive & negative cables off the battery. 2-Touch cable ends together & hold for 60 seconds & let go. 3-Wait 15 minutes. 4-Close all doors,Reconnect battery cables, starting with postive cable first. 5-lock and unlock truck using driver side door and try ...

Unfortunately, the PATS reset or relearn has to be performed with a dealer scan tool or high-end scan tool like what a shop or dealer uses. Posted below is the procedure they will follow to reset or relearn the PATS system. They will usually charge around $100 to diagnose the issue and relearn the PATS system.

22 years of Ford service, and Ford senior master certified in diesel, gasoline and hybrid vehicles 2,133 Satisfied Customers Ford f 150 need to reset antitheft.

That is the PATS (passive anti-theft system). I am assuming that the red light is flashing rapidly (two times a second) indicating that an improper key was used or that there is a problem with system. If you used an older, unprogrammed key, it will lock the system but only for a few minutes. It should automatically reset.

Do I install it before I do the pats parameters reset Ford. ... Seeking help in resetting Ford PATS on a ...

Accolades include being a 2005 Ford PTS Regional Finalist and 2006 ASE Ford National Technician. 5,427 Satisfied Customers Have just purchased my third Explorer, a 2006 Eddie Bauer V8.

Mar 6, 2011 · The owner wants to erase the lost key from the PATS memory and program new one (for this purpose a blank key is purchased). There is no way to delete a single key, only all known keys can be erased. So the user has to perform the operation in 2 steps: remove all keys known by PATS and program the old key and the new key