I need help on this question

Q: 3. I don't have a driving licence. I can't drive you there.If I. driving licence, I could drive you…

A:

Q: What is the value of the resistor shown below in ohms? Don't use scientific notation. #1

A: Resistors can be used for both electrical and electronics circuits when current is passed voltage…

Q: (c) Besides using strain gauges, name and describe two alternative ways of measuring strains or…

A: we need to name and describe two alternative ways of measuring strains or deformations besides using…

Q: A high voltage transmission line transmitting 10 MW of power operates at a voltage of 105 KV…

A:

Q: What is the maximum number of 15 ampere lighting circuits required if the dwelling has an occupied…

A: Refer the table 220.12 from the NEC, the minimum load requirements for the dwelling load unit is,

Q: 7. Which chapter of the National Electrical Code covers communications systems installations and…

A: In the National Electrical Code chapter 8 , covers the communications systems installations…

Q: HERE IS IT

A: Physical address can be expressed by the following formula:Physical Address = (Segment Address) x 10…

Q: Look at the photo and answer the questions

A:

Q: 1. Referring to voltage levels, what is EHV a. Extra High Voltage b. Extreme High Voltage c. Extra…

A: The correct answer is:a. Extra High VoltageExtra-high voltage (EHV) refers to voltages in the range…

Q: Can you please further explain this section.

A:

Q: Hi for case 3 is explain on which question ? either (a) positive or negative or for question (b) pls…

A:

Q: (a) aluminium, (b) copper, (c) iron, (d) magnesium, and (e) zinc?

A: Aluminum, Magnesium metals are used as the Matrix material in fiber-reinforced MMCs.

Q: In an electrical system, each of the service entrance conductors has an area of 750 kcmil. The size…

A: Given: In an electrical system, each of the service entrance conductors has an area of 750 kcmil.

Q: what is the statement of Lenz law.

A: Lenz's Law states:"The direction of an induced electromotive force (EMF) and the resulting current…

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.